Early 1870s Crinolette

The very full-skirted shape of the early 1870s can be difficult to achieve with petticoats alone. And even if you can get the correct volume, that means layers and layers of petticoats sticking to your legs. For a summer dress, I wanted a hoop and bustle combo - a.k.a. crinolette - that would hold my skirts out, give the correct, very large shape, and be comfortable to wear.

Here's the finished crinolette.

Here it is under a petticoat.

I used this diagram from Corsets and Crinolines as a guide.

Obviously mine didn't come out exactly like this one! I couldn't figure out how to make the bustle part connect to the hoop like in the book, so I just let it float. I also lengthened the whole thing a bit; I wanted it to be short enough not to trip on, but long enough to hold my skirt out at the bottom.

The diagram is also not perfect. There are lengths written in for a few of the bustle wires, but they didn't correspond to the size of the fabric piece when scaled up. The bustle portion's waist also did not fit with the skirt portion (between X and Z) and no pleats are indicated to make it fit. So I took this as an inspiration and just fiddled with it until it worked.

I sewed the fabric structure from plain white cotton (some of it recycled from old sheets) and made the channels from white cotton twill tape. I didn't bother with seam finishes because this was an experiment and I wasn't sure if it was going to work.

The lower part was easy - just hoops! I used wide German plastic boning. This was ideal material; the hoop was supportive but very flexible, not rigid, making it easy to sit, get in the car, and move past obstacles, and keeping the look of the dress soft. The lowest hoop is about 85" in circumference.

I rounded the ends with a scissor, overlapped them by about 1", punched two holes in each end with a very small hole punch, and sewed the ends together with strong thread. Then I slid the joins into the channels, making sure to stagger them throughout the hoop.

The bustle portion was more challenging. Getting the shape just the way I wanted was tricky. Here I used plastic-covered double-steel hoop wire, and I played around with the lengths until I liked the shape.

I cut the lengths and covered the ends with tape (yeah, I know boning caps exist, but I didn't have any handy) then sewed each end through the plastic middle part of the boning (using a big strong needle and some muscle!) and the fabric and twill tape channel, to keep it from shifting.

I tied a piece of twill tape to connect the bustle portion to the hoop to prevent it riding up and shifting.

Even after I finalized the hoop lengths, the back seemed not quite right, so I sewed a small pad (which I just happened to have sitting around leftover from a different project a couple years ago - yay for re-use!) into the back waistband. The pad is a rounded shape about 8" x 11", stuffed with fiberfill into a soft, flat shape. It was stuffed more firmly when I found it, but I took some out because it made the bustle just a bit higher than I wanted.

The crinolette came out a bit funny looking, but under a dress it really works! And it's so comfortable to have your petticoats not sticking to your legs - I felt so light and cool!

I wore this under my new floral lawn 1870s dress, which you can see here!